- HONDA VTX BATWING FAIRING WINDSHIELD C R S 1800 1300 BAGGER 6x9" SPKS
- INCLUDED: 1) HONDA VTX FAIRING 6x9” INCHES SPEAKER HOLES. 2) 5 INCHES WINDSHIELD 3) 6 O-RINGES 4) NUTS AND BOLTS TO PUT THE FAIRING TOGETHER. (STAINLESS STEEL NUTS AND BOLTS).
- FAIRING ARRIVES IN GELCOAT BLACK. PREP WORKS WILL BE NEEDED BEFORE FAIRING CAN BE PAINTED.
The 1800 fairing can fit on the Honda VTX 1300 Honda VTX 1300 R & S models: The R & S model fork tubes between the triple trees are covered with sheet metal shrouds that have to be removed for the fairing installation. This entails you to remove the top tree to slide the shrouds off the tubes, which should be done according to your shop manual. After you have removed the shrouds, the fairing can be installed on the bare fork tubes with the use of PVC pipe spacers. The spacers are needed because the inverted forks on the 1800 model (which the fairing is a custom fit to) are a larger diameter than the 1300 model. Without the spacers the mounting clamps would crush the fiberglass fairing. Honda VTX 1300 C model: The C model fork tubes needs only the spacers to physically mate up the fairing, but there is a interference problem with the turn signals. They have to be removed from the fork tubes to allow the fairing to be mounted. If relocated below the lower tree they may interfere with the front suspension travel, so we don't recommend that. Custom turn signals are suggested. *** BIKE MUST BE EQUIPED WITH HARDWARE TO ACCEPT NORMAL WINDSHIELD IN ORDER TO ACCEPT THIS FAIRING. WE ONLY PROVIDE THE HARDWARES TO ATTACH THIS FAIRING TO YOUR ORGINAL HARDWARE. Comes in primer, 100% hand laid fiberglass construction - lighter and much stronger than plastic. We put extra care into our finishes .They weight roughly 15 lbs and are just about ready to paint.